Bibs Glass bottle Baby Bottle Complete 225 ml + latex teat slow food flow - Cloud

WARNING AND SAFETY INSTRUCTIONS

Instructions for use: Please read this information carefully and keep it for later use. For the safety and health of your child. WARNING! Continuous and prolonged sucking of liquids causes tooth decay. Always check the temperature of the food before feeding. Discard the product immediately at the first signs of damage or defects. All unused parts must be kept out of reach of children. Never attach cords, ribbons, shoelaces or parts of clothing to the product. Risk of strangulation! Feeding teats must never be used as a pacifier. Glass bottles can break. This product may only be used under adult supervision. Accidents due to falls have occurred when babies were left alone with the drinking vessel. Tooth decay can also occur in toddlers even when unsweetened liquids are used. This can happen if the baby uses the bottle over a long period – during the day and especially at night, when saliva flow is reduced. Disassemble and clean the product before first use and boil the parts for five minutes to ensure hygiene. Clean it thoroughly before each further use to ensure hygiene. Be especially careful when heating in the microwave; local overheating can occur. Always stir the warmed food and check the temperature before feeding. When warming baby food, heat it separately and then pour it into the bottle. You can also slowly heat the bottle filled with food in the microwave – without the other parts. Reassemble the bottle after heating and ensure the ring is firmly in place. Do not use the oven or stove for heating. Teats: Clean and sterilise the teat before each use by pouring boiling water over it and leave it in the hot water for about five minutes. Do NOT use cleaning agents or a dishwasher. Check the teat before each use by pulling it in all directions. Inspect it thoroughly before use and replace it at the first signs of damage or wear. Do not expose the teat to direct sunlight or heat, and do not leave it in disinfectant longer than recommended, as this can impair the teat. The bottle and other parts except the teat and funnel: Can be washed by hand or in the dishwasher on the top rack. Dishwasher safe, however, long-term damage such as discolouration cannot be excluded. Wash these after each use. Use hot soapy water and rinse off excess soap. Ensure no soap residue remains. Allow all parts to dry completely before reassembling. Heat only the bottle body and not plastic parts or the teat in the microwave. Please ensure the child uses the baby bottle only for its intended purpose. Do not allow the child to chew on the teat or use it as a pacifier, even if it is attached to the bottle. Remove the bottle when it is empty or the child can no longer drink. Do not store the product in damp environments or near heat sources. Natural rubber teats may cause an allergic reaction in some children. Remove the adhesive point before first use.